Changshu Xingliheng Wood Machinery Co., Ltd
Changshu Liheng Wood Machinery Factory

Service hotline
0512-52594802-807
News Detail

What are the common faults of veneer dryer?

Issuing time:2017-11-10 13:30

Veneer dryer is one of the most commonly used wood drying equipment, so the failure is inevitable, but as long as we find out the cause of the fault, give reasonable solution, the problem will be solved. Here we look at the veneer dryer common faults and troubleshooting.


1, after drying, the moisture content of the veneer is still very high, it is necessary to adjust the production capacity of the dryer, increase or reduce the supply of heat.

2, the meshing gap between the large and small gear will be too large, will bring some influence to the normal use, check the tug, gear wheel wear, small gear wear seriously, according to the wear of the reverse side of the installation or replacement of new gear.

3, the veneer dryer has vibration of the whole body, there are two reasons, check the connection between the tugboat device and the base, there is no dislocation, adjust the fastening parts to make the position correct; roll side wear, according to the degree of wear, replace the new rolling ring.

In the process of using veneer dryer, it may encounter other problems. If it can not be solved by itself, it is suggested to contact with manufacturers to solve the problem, and don't disassemble and repair blindly


Share to:
Contact us
Address: Yunan Village, Haiyu Town,
Changshu City, Jiangsu Province, China 215517
Tel:+86-0512-52596277
      +86-0512-52594806
Fax:+86-0512-52597239
Email:info@csliheng.com
            lhzhougang@126.com
Our products
BG183A 3 Layers Net-belt Veneer Dryer
BG183 2 Layers Mesh-belt Veneer Dryer
BG13 Series Veneer Roller Dryer
BS Series Stainless Steel Mesh-belt
Veneer Dryer
BG19 Series Mesh-roller Combined Veneer Dryer
BG1933 Mesh-roller Combined Veneer Dryer
BSJ Double Cylinder Scissor Lift
BG1344-12+2 4 layers veneer roller dryer