What are the common faults of board dryer?

Veneer dryer is one of the most commonly used wood drying equipment at present, so failure is inevitable, but as long as we find out the cause of failure, give a reasonable solution, the problem will be easily solved. Let's take a look at the common faults and troubleshooting methods of the veneer dryer.

1, after drying, the moisture content of veneer is still very high, it is necessary to adjust the production capacity of the dryer, increase or reduce the supply of heat.

2. If the meshing gap between large and small gears is too large, it will affect the normal use to some extent. Check whether the tugboat and the retaining wheel are worn or not, and the pinion is seriously worn.

3. There are two reasons for the whole body vibration of the veneer dryer. Check whether the connection between the tug device and the base is misaligned, and adjust the fastening connection part to make the position correct; The side of the ring is worn. Replace the ring according to the degree of wear.

When using the board dryer, you may encounter other problems. If you cannot solve them by yourself, you are advised to contact the manufacturer for help. Do not blindly disassemble and repair the board dryer